1 isdn-bri settings, Isdn bri switch type, Line setup – TANDBERG Maestro MXP User Manual

Page 213

Advertising
background image

Administrator Settings

213

5.8.1.1 ISDN-BRI Settings


To make sure your system will work properly using ISDN-BRI, make the following settings:

1. Set ISDN switch type
2. Enter ISDN line numbers (+ SPIDs if required)
3. Disable unused lines


Some software versions do not support 6 ISDN lines, therefore some of the Line Setup entries
may be grayed out.

ISDN BRI switch type

Select the type of ISDN network connected to your unit. Note that 1TR6 should only be used if
you are operating the system behind a PABX.

Line setup

This menu allows you to program the numbers associated with your ISDN line. If you want to use
this ISDN line, you need to set Enabled On and enter the numbers of your ISDN line. If some of
the ISDN lines are not to be used, set Enabled Off. Line 1 should always be enabled. National
ISDN and AT&T Custom ISDN might require SPID numbers associated with your ISDN numbers.
If you have received two different SPID (Service Profile IDentifier) numbers for each ISDN line
from your network provider, you must program both of them.


Example:

Numbers

SPIDS

ISDN BRI 1:

67838498
67838498

016783849800
016783849810

ISDN BRI 2:

23478060
23478070

012347806000
012347807000

ISDN BRI 3:

23478420
23478430

012347842000
012347843000

ISDN BRI 4:

23478520
23478530

012347852000
012347853000

ISDN BRI 5:

23478540
23478550

012347854000
012347855000

ISDN BRI 6:

23478560
23478570

012347856000
012347857000


Advertising