Yamaha PSR-510 - Manual (Page 60)

58
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |
MIDI Reception Modes
The [RECEIVE CH/CL/COM] button is used to specify the reception mode for each of the 16 MIDI channels,
the internal or external clock mode, and MIDI start/stop command reception mode.
■ Channel Reception Modes
The PSR-510 allows any of five reception modes to be individually assigned to MIDI channels 1 through 16.
The five modes are:
Mode “0” RX OFF: Reception disabled.
Mode “1” MULTI: Received MIDI note data directly controls the PSR-510 tone generator. Dif-
ferent voices can be played on different channels.
Mode “2” REMOTE: Received MIDI note data is handled in the same way as data from the
PSR-510’s own keyboard.
Mode “3” CHORD: Received MIDI note data is interpreted as Auto Accompaniment chord
commands.
Mode “4” ROOT: Received MIDI note data is interpreted as Auto Accompaniment bass note
commands.
MIDI
NOTES
• The send channel must correspond to the channel set for the modes
2-4.
• If the PSR-510 receives more than one note at the same time while
mode “4” (ROOT) is selected, the last note will be interpreted as the
Auto Accompaniment bass note.
+–
1_ _ 9
X
Select the Desired Mode ........................................................................................................................
Use the [+/–] button in the number-button row to select the desired re-
ception mode for the selected channel. The modes are selected in sequence
each time the [+/–] button is pressed, and the mode number appears on the
left digit of the MULTI DISPLAY.
NOTES
• The currently selected reception mode is retained in memory even
when the power switch is turned off, as long as batteries are installed
or an AC adaptor is connected.
Mode number
Z
Press the [RECEIVE CH/CL/COM] Button & Select a Channel ...........................................................
Press the [RECEIVE CH/CL/COM] button, then use the [+] and [–]
buttons, the number buttons, the data dial, or the [RECEIVE CH/CL/
COM] button itself to select the MIDI channel (1 … 16) for which you
want to specify a new reception mode. The channel number appears on the
right of the MULTI DISPLAY.
NOTES
• “cL” and “cd” will appear on the right of the display if you increment
above channel number 16 or below channel number 1. These selec-
tions are used for the Clock Mode and Start/Stop Mode functions
described below.
RECEIVE
CH/CL/
COM
MODE ................
0 RX OFF
1 MULTI
2 REMOTE
3 CHORD
4 ROOT
Channel number