Western Telematic MPC-20VS16-3 - Manual (Page 126)

7-15
Alarm Configuration
• Plug Access: Determines which Plug(s) will be switched when the temperature
exceeds the Alarm Set Threshold and the Load Shedding feature is triggered at
the selected unit. For example, if plugs A1, A2 and A3 are selected, then these
plugs will be switched On or Off whenever the temperature exceeds the Alarm
Set Threshold at the selected unit/branch/line. (Default = undefined.)
Notes:
• In the Web Browser Interface, Plug Access is configured by clicking on the
"plus" symbol in the "Configure Plug Access" field to display the drop down
menu, and then selecting the desired Plug(s) from the drop down menu.
• If your installation includes optional AUX units, please refer to Section 7.2.1.3
for additional instructions regarding granting access to plugs on AUX units.
• Plug Group Access: Determines which Plug Group(s) will be switched when the
temperature exceeds the Alarm Set Threshold and the Load Shedding feature
is triggered at the selected unit. For example, if you have defined a Plug Group
named "test", which includes Plugs B3, B4 and B5, and then selected the "test"
Plug Group via the Plug Group Access parameter, then all of the plugs in the
"test" Plug Group will be switched On or Off whenever the temperature exceeds
the Alarm Set Threshold at the selected unit. (Default = undefined.)
Notes:
• In the Web Browser Interface, Plug Group Access is configured by clicking
on the "plus" symbol in the "Configure Plug Group Access" field to display
the drop down menu, and then selecting the desired Plug Group(s) from the
drop down menu.
• Plug Groups must first be defined (as described in Section 5.6) before they
will be displayed in the Load Shedding menu's Plug Group Access submenu.
4. After setting parameters for a given unit, you may also define additional parameters
for other attached units. To set Load Shedding parameters for other units, return to
the Alarm Configuration menu and then repeat steps two and three.