Western Telematic MPC-20VS16-3 - Manual (Page 19)

2-7
Unit Description
13. Power Inlet(s): The power inlets are configured differently on MPC models, in
accordance with the power rating, maximum load and the number of power circuits.
Depending on your specific model, the MPC may include either one or two power
inlets or either one or two power supply cables. Other MPC models may include
either one or two permanently attached power supply cables. For a description of
the power input configuration for your specific MPC unit, please refer to the table in
Section 1 or Section 3. Note that MPC models with detachable power cable(s) will
also include a power inlet cable keeper.
2.4. Additional Button Functions
In addition to the button functions discussed in Sections 2.1, 2.2 and 2.3, the Default,
Audible Alarm and Display Selection buttons can also be used to perform several
additional functions described below:
Notes:
• All Front Panel Button functions can also be disabled via the System
Parameters menu, as described in Section 5.3.
• When the MPC is reset to factory defaults, all user-defined configuration
parameters will be cleared, and the default “super” user account will also be
restored.
1. Reboot Operating System:
a) Press and hold the Default button for five seconds, and then release it.
b) The MPC will reboot it's operating system; all plugs will be left in their current
On/Off state.
c) If the optional MPC-DISPLAY unit is installed, and this operation is performed at
the MPC-DISPLAY unit, all connected MPC units will also be rebooted.
2. Set Parameters to Factory Defaults:
a) Simultaneously press both the Default button and the Display Selection button,
hold them for five seconds, and then release them.
b) All MPC parameters will be reset to their original factory default settings, and
the unit will then reboot. All plugs will be left in their current On/Off state.
c) This function will not be applied to other connected MPC units.
3. Toggle/Default All Plugs:
a) Simultaneously press both the Default button and Audible Alarm button, hold
them for five seconds, and then release them.
b) The MPC will switch all plugs to the Off state. If all plugs are already in the Off
state, then the unit will reset all plugs to their user defined default states.
c) This function will not be applied to other connected MPC units.