Yamaha RGX620Z-D6 User Manual

Yamaha Musical Instruments

Advertising
background image

QC71550 0112

Printed in Taiwan

String Action

Adjust the tremolo unit height by rotating the height adjustment bolts q.

Intonation Adjustment

If the pitch at the 12th fret is sharp compared to the harmonic tone:

→ Turn the intonation adjusting screw w clockwise.

If the pitch at the 12th fret is flat compared to the harmonic tone:

→ Tune the intonation adjusting screw w counter-clockwise.

Arm Tension

Turn the arm tension screw e clockwise to make the arm tighter.
Turn the arm tension screw e counter-clockwise to make the arm looser.

Volume Control

Pickup Selector

Tone Control

Output Jack

Battery Compartment

* No battery needed to use

magnetic pickup only

Volume Control

(for output jack #1)

Pickup Selector

Front Pickup

Rear Pickup

Tone Control

Output Jack #1

* Output only from magnetic pickup
* Bypass pre-amp inside (passive)

Battery Compartment

* Battery needed to use

output jack #2

Pickup Selector

Front Pickup

Rear Pickup

Tone Control

for magnetic pickup

Output Jack #2

* Output from magnetic & piezo pickup
* Output through pre-amp inside (active)

Piezo Pickup
Bridge

Inside Knob:

Volume Control for
output jack #2

Outside Knob

Panpot for magnetic/piezo
* Clockwise for magnetic.

Counter-clockwise for piezo

NOTE 1 Output jack #1 & #2 can be used at one time.
NOTE 2 When not in-use, unplug from output jack #2 to save battery.

Output jack #1 dose not consume battery.

1. To use magnetic pickup only,

plug into output jack #1.

2. To use both magnetic & piezo pickup,

plug into output jack #2.

Front + Rear

Front + Rear

Front Pickup

Rear Pickup

Front + Rear

q

w

e

The SPERZEL “Trim-Lok” tuners offer easy string change
and improved tuning stability when using the tremolo bridge.

1) Loosen the knob q on the back of the tuner. As the

locking pin w in the string post goes down, remove the
old string.

2) Place the new string from the bridge into the string hole

e of the string post.
Do not wind the string around the post.

3) Pull the new string tightly and tighten the knob q to lock

the string.

4) Tune the strings to the pitch.

NOTE

Don't loose the knob q too much. It may drop out the
tuner.

q

Tighten

Loosen

w

e

Advertising
This manual is related to the following products: