Xerox WorkCentrePro - Manual (Page 101)

Selecting Transport Protocols
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 System Administration Guide 101
http://vvv.xxx.yyy.zzz
If the Port number is set, append that to the internet address as follows. In this example,
the port number is 80.
http://vvv.xxx.yyy.zzz:80
3. Verify that the home page of CentreWare Internet Services is displayed.
The CentreWare Internet Services installation process is now completed.
If the test fails, refer to the Problem Solving chapter for assistance.
NOTE: If the Auditron feature is enabled, you may be required to enter the user ID
and password (if one is set up). If you need assistance, contact the Key Operator.
NOTE: When your access to CentreWare Internet Services is encrypted, enter
“https://” followed by the internet address, instead of “http://”.
Selecting Transport Protocols
When using the NetWare, SMB, or SNMP port, change the transport protocol if
required.
• NetWare: IPX/SPX , TCP/IP
• SMB: NetBEUI, TCP/IP
• SNMP: UDP, IPX
1. At the CentreWare Internet Services home page for the machine, select the
[Properties] tab.
2. In the [Properties] frame, select [Port Status].
3. Select the required transport protocol.
NetWare: IPX/SPX , TCP/IP
SMB: NetBEUI, TCP/IP
SNMP: UDP, IPX
4. Select [Apply New Settings].