Request fan speed, Fan speed state, Update rate – MITSUBISHI ELECTRIC LMAP-02E User Manual

Page 13

Advertising
background image

02_NVspec_ver202e_pdf.xls 4_Network Variables

7n

Request Fan Speed

network input SNVT_switch nviFanSpeed_n;

This input network variable is used to change the fan speed of the indoor unit or Ventilator (in case of

independent operation). This nv is not required to use when setting the airflow rate only from the local side

such as the local remote controller.

Valid Range

value field : 0% to 25% = Fan Speed Low

value field : 25.5% to 50% = Fan Speed Mid 2

value field : 50.5% to 75% = Fan Speed Mid 1

value field : 75.5% to 100% = Fan Speed High

: Else = Fan Speed High

state field : not used

* As the number of the step for fan speed differs depending on the model of the indoor unit.

Each indoor unit runs actually as follows. The data received is retained continually.
3-step model : Mid-2 is accepted as Mid-1.
2-step model : Mid-2 and Mid-1 are accepted as Low.
1-step model : Low, Mid-2 and Mid-1 are accepted as high.

Default Value

The default value is determined by the state of the air conditioner (indoor unit).
This variable becomes value = 0 until the value is updated after the power supply of LM-AP.

8n

Fan Speed state

network output SNVT_switch nvoFanSpeed_n;

This output network variable indicates the present airflow rate of the indoor unit fan.

Valid Range

value field : 0% to 25% = Fan Speed Low

value field : 25.5% to 50% = Fan Speed Mid 2

value field : 50.5% to 75% = Fan Speed Mid 1

value field : 75.5% to 100% = Fan Speed High

state field : not used  =0 constantly
*The value is 0 while LM-AP is initialized.

When Transmitted

This output network variable is transmitted promptly when the state changes.

It is also transmitted as the state changes by the operation from the local such as the local remote

controller.

This variable is output by the ncilnitStartTm (Initialize Start Time) at the powering of LM adapter.

Update Rate

Update Rate

Update Rate

Update Rate

The value defined by nciSndHrtBt_1(SendHearbeat_1) is valid.

Default Service Type

Acknowledged

WLN01-1023(Ver2.02)

- 13 -

Advertising