Yamaha WC42260 - Manual (Page 113)

Aux Send Pages
113
DM2000 Version 2—Owner’s Manual
6 To set the Pre Fader and Post Fader parameters, select the PRE/POST but-
tons, then use the [ENTER] button or INC/DEC buttons.
7 To set all Input Channels for the selected Aux Send to pre-fader or post-fader
simultaneously, select the GLOBAL PRE or POST button, and then press
[ENTER].
The PRE or POST button is highlighted, and remains highlighted as long as all Input Chan-
nel pre or post settings remain unchanged, so you can quickly see if all Input Channels are
set to either pre-fader or post-fader.
8 If you selected pre-fader, turn on the PRE ON button or POST ON button to
set the Pre point before or after each channel’s [ON] button.
Fixed Mode
See page 110 for information on how to select Fixed Aux mode.
1 Use the AUX SELECT [DISPLAY] button to select the Aux Send pages.
The Input Channel 1–24 Aux Send page in Fixed mode is shown below. The layout of the
other three Aux Send pages in Fixed mode is the same.
2 Use the AUX SELECT [AUX 1]–[AUX 12] buttons to select Aux Sends 1–12.
3 Use the cursor buttons or Parameter wheel to select the Aux Send buttons.
Input Channels can also be selected by using the Input Channel Layer buttons and [SEL]
buttons.
4 Use the [ENTER] button or INC/DEC buttons to turn Aux Sends on and off.
If the Fader mode is set to Aux/Mtrx, the faders provide a visual indication of the On/Off
status of each Input Channel for the currently selected Aux Send. For Aux Sends that are on,
faders move to the nominal position. Aux Sends that are off, they move to the –
∞ position.
On/Off settings cannot be changed by using the faders.