Xerox 4213 - Manual (Page 75)

XES COMMAND LANGUAGE MODE
Font Select
Purpose Selects a font from those listed in the index created with Font ID
Assignment.
Syntax
E n
n The ID number for the font, from 0 to 9.
Where to place it Anywhere in the document at which you want to use this font.
Example From the following index:
E +0Classic8iso-L L
E +1Classic8Biso-L L
E +2Classic6iso-L L
E +3Classic12iso-L L
E +4Classic10iso-L L
to select Classic8Biso-L within a document, enter:
E 1
More If you specify a number that is not assigned first with a Font ID
Assignment, the printer continues printing with the current font.
An error message appears on the Summary Sheet.
To select the default landscape font (without having assigned a
font ID), use
E 0.
To select the default portrait Titan font (without having assigned
a font ID), use
E 1.
You may want to select either the default portrait or landscape
font to identify the page orientation. The first font called out
determines the orientation of the page.
Setting units of measure
Margins and tabs are set either in units of five pixels (1/60 inches)
or in units of one pixel (1/300 inches). You select the unit of
measure by entering Units—1/60th or Units—1/300th. The Units
commands are entered before those for margins or tabs settings.
They need not be entered immediately before, however. You do
not need to enter a Units command more than once in a job.
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE 2-37