Engine starting – FIAT Multipla User Manual

Page 166

Advertising
background image

165

SAFETY DEVICES

CORRECT USE OF THE CAR

W

ARNING

LIGHTS AND MESSAGES

CAR

MAINTENANCE

TECHNICAL

SPECIFICA

TIONS

INDEX

DASHBOARD AND CONTROLS

IN AN

EMERGENCY

ENGINE STARTING

EMERGENCY START-UP

If the Fiat Code system cannot deactivate the engine
immobiliser, the warning lights

¢ and U will remain

lit and the engine will not start. To start your car
follow the emergency start-up procedure.

Read the whole procedure carefully before trying to
carry it out. If you make a mistake, you must turn the
ignition key back to STOP and repeat the whole
operation from beginning (step 1).
❒ Read the 5-figure electronic code given on the

CODE card.

❒ Turn the ignition key to MAR.
❒ Press and hold down the accelerator pedal. The

warning light

U turns on for about 8 seconds, and

then goes off; release the accelerator pedal and get
ready to count the flashes of the

U warning light.

❒ Count the number of flashes that corresponds to

the first figure of the code on the CODE card, then
press the accelerator pedal and keep it there until
the

U warning light comes on (for 4 seconds) and

then goes off; release the accelerator pedal.

❒ The warning light U will start flashing again: after it

has flashed the number of times that corresponds to
the second figure on the CODE card, press the
accelerator pedal to the floor and keep it there.

❒ Do the same for the remaining figures on the

CODE card.

❒ Once the final figure has been entered, keep the

accelerator pedal pressed. The warning light

U will

light up for 4 seconds and then go out; release the
accelerator pedal.

❒ Rapid flashing of the warning light U (for about 4

seconds) confirms the operation has been carried
out successfully.

❒ Start the engine by turning the ignition key from

MAR to AVV.

If however the warning light

U stays on, turn the

ignition key to STOP and repeat the procedure from
step 1.

IMPORTANT After an emergency start-up, you should
contact a Fiat Dealership otherwise you will have to
repeat the procedure described each time you want to
start the engine.

Advertising