FIAT Multipla - Manual (Page 196)

195
SAFETY DEVICES
CORRECT USE OF THE CAR
W
ARNING
LIGHTS AND MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICA
TIONS
INDEX
DASHBOARD AND CONTROLS
IN AN
EMERGENCY
Certain fuses are protected by a plastic grid.
To replace these fuses, first of all remove the grid
using a screwdriver. Replace the blown fuse and refit
the plastic grid.
To locate the fuse, refer to the tables on the following
pages.
FUSE BOX
The fuse box is located under the oddments tray on
the driver’s side.
The fuse location (n. 16 to n. 28) is not binding; to
replace a blown fuse, refer to the fuse colour that
must be the same as the fuse box colour.
To reach the fuses:
❒ Raise the oddments tray compartment flap.
F0E0694m
The numbers indicating the electrical components
corresponding to each fuse can be seen on the inside
of the flap inner wall.
❒ Take out the inner cover, rotating the two knobs
(A).
The group of fuses marked with letter (B) contains
spare filaments.
To facilitate fuse replacement, use the pliers (C)
located near the fuse box.
After use return pliers to their place.
IMPORTANT Never turn the ignition key to MAR
with a fuse removed; doing so would turn on warning
light
¬ and the “fault” would be stored by the airbag
control unit. In such an event, go to Fiat Dealership to
reset the fault stored on the airbag control unit.