Acura 2012 TL - Manual (Page 206)

Push the right side of the switch, HI,
to rapidly heat up the seat. After the
seat reaches a comfortable
temperature, select LO by pushing
the left side of the switch. This will
keep the seat warm.
The ignition switch must be in the
ON (II) position to use the heaters.
Both front seats are equipped with
seat heaters. Because of the sensors
for the side airbag cutoff system,
there is no heater in the passenger’s
seat-back.
TL and TL with Technology Package
models
SH-AWD and SH-AWD with Technology
Package models
Seat Heaters
202
SEAT HEATER SWITCHES
HEATERS
Passenger’s Seat
Driver’s Seat
11/01/14 18:29:20 31TK4630_207
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
Models equipped with the keyless access
system have an engine start/stop button
instead of an ignition switch. ON Mode
is the equivalent of ON (II). For more
information, see pages
184 and 187 .
:
In the HI setting, the heater turns off
when the seat gets warm, and turns
back on after the seat’s temperature
drops.
In the LO setting, the heater runs
continuously. It does not cycle with
temperature changes.
2012 TL