ACU-RITE VRO 300M - Manual (Page 57)

Setup VRO 300M
50
Calculated Entry
This brings up the softkeys needed to have the readout calculate
the compensation factors.
The
NEW
SEGMENT softkey brings up the
CALCULATE SEGMENT form.
S
TANDARD —This is where you enter the actual
length of the standard.
T
RAVEL
—Shows the measured length of the
standard. This would normally be slightly
different from the actual length because of
machine inaccuracies.
F
ACTOR —This is the compensation factor
calculated by the readout.
CALCULATE
COMP
STANDARD
0.0000
CALCULATE SEGMENT
TRAVEL
0.0000
FACTOR
0000 PPM
NEW
SEGMENT
CLEAR TABLE
ANCHOR
SEGMENT 1
CANCEL DONE