Olympus IPLEX MX II User Manual

Page 26

Advertising
background image

20

Chapter 3 Preparation and inspection before observation

CAUTION

• Place the main unit on a level surface so it is stable. The main unit can tip over if it is not

stable.

• Do not place the main unit in overhead location. Doing so may result in the main unit falling

and being damaged.

• When suspending the base unit while using it, hook the handle someplace that can support

its weight and where there is no danger of it falling.

• When mounting the tripod to the main unit, install it so the tripod platform does not run up on

the protrusion on the rear of the main unit. Affixing the tripod with the platform installed at an
angle can cause the main unit to fall off. You can use a platform with a size that is less than
45 mm from the center of the tripod screw.

• Setup the tripod on level ground. Setting the tripod up on a slope or uneven ground is

dangerous because it may fall over.

• Be careful not to accidently move the lock release lever on the battery cover and open it

when handling the main unit.

Protrusion

Advertising