EVS MulticamLSM Version 10.04 - January 2011 Operating Manual - Manual (Page 22)

Issue
10.04.A
EVS Multicam Version 10.04 – Operating Manual
EVS Broadcast Equipment SA – January 2011
12
F
UNCTION
K
EYS IN THE
M
AIN
M
ENU
Select the corresponding Function key (F_ key), and then press ENTER to validate
the selection.
Function Key Use
F1 to F4 If desired, the Multicam system can be run using 1, 2, 3 or 4
EVS Remote Panels. Depending on the number of play
channels available in the current configuration, 1-, 2-, 3- or 4-
Remote modes will be available from the Main menu.
F1: 1 Remote One Remote Panel is used in the configuration
F2: 2 Remotes Two Remote Panels are used in the configuration.
If 4 play channels are available, when selecting the 2 Remotes
mode, the operator can chose between 2 configurations:
• 2 play channels for each remote:
In this configuration, each Remote Panel can select
PGM+PRV or 2PGM mode. Each Remote Panel can manage
video transitions (cut, mix, wipe) in PGM+PRV and playlist
modes.
• 3 play channels for the 1 s t remote and 1 play channel for
the second remote.
In this configuration, the 1
s t remote can select PGM+PRV or
3PGM mode and can manage video transitions. The 2 n d
remote is forced to 1PGM mode and can only handle cut
transitions.
F3: 3 Remotes Three Remote Panels are used in the configuration.
F4: 4 Remotes Four Remote Panels are used in the configuration.
F5: Char. On/Off Enables or disables the on-screen display (Timecode, Clip
ID,…) on the output monitors.
F6: Exit Exits the Multicam software and returns to the EVS Menu.
F7: Clear all
clips
Clears all clips. All clips will be lost. A confirmation of this
command is required.
For more information to this action, refer to the section 9.2.6
‘Clearing Clips’, on page 43.
Note: This command is not similar to the Clear Video Disks
from the Maintenance menu. If you wish to refresh completely
the server, i.e. to clear all c lips inc luding the protected ones,
you need to use Clear Video Disks rather than Clear all clips.
F8: Stop Record Stops the record. The REC key will go off and the F8 function
key is now used to restart the record.
F9: Fill Playlist «Dump» feature which allows all c lips to be «dumped» at the