EVS MulticamLSM Version 10.04 - January 2011 Operating Manual - Manual (Page 49)

EVS Multicam Version 10.04 – Operating Manual
EVS Broadcast Equipment SA – January 2011
Issue
10.04.A
39
• The guardband beyond the Short OUT point is created with the
material available when the operator saves the clip by pressing the
selected F_ key. Therefore, this guardband can sometimes be shorter
than the value defined in the Setup menu.
9.1.2 C
LIP
A
VAILABILITY ON
D
ISKS
Various clip t ypes can be distinguished depending on whether they are available
on the disks or not. Depending on the clip availability on disks, you can perform
specific actions on the given clip or not.
Clip on disk Clips which are protected on disks, and which have Short
IN and Short OUT points present on disks.
All the material is available on the disk.
Growing clip Clips which are protected on disks, and which have a Short
IN point, and possibly Short OUT point defined on disks.
Since the record process is still undergoing, some of the
material is already on the disk but not all of it.
Reserved clip Clips for which the position has been reserved on the SDTI
database but for which there is no Short IN and Short OUT
points, nor any protect present on disks.
9.2 USING THE EVS REMOTE PANEL
9.2.1 H
OW TO
C
REATE A
C
LIP
To define a clip, proceed as follows:
1. Select the LIVE mode.
2. Using the jog dial, define your Short IN point. Press the IN key to mark your
Short IN point of the clip.
3. Search for the desired Short OUT point and then press the OUT key to mark
it.
A clip can be created with only IN point or only OUT point. The system will
automatically define the clip duration according to the default duration defined in
the Setup menu.
Note
You can mark an IN or OUT point on a paused record train and go back to
live without losing the point marked by pressing SHIFT-<Return>.