EVS MulticamLSM Version 10.03 - July 2010 Configuration Manual - Manual (Page 23)

Issue
10.03.C EVS Multicam – Version 10.03 – Configuration Manual
EVS Broadcast Equipment SA – July 2010
16
2.3.2 VITC/ANC M
ANAGEMENT IN
HD IN
AND
HD/SD OUT
In HD, the page is as follows:
The following parameters can be defined:
IN LOOP
D-VITC The TC and user bits are always written on the monitoring SD
outputs of the record codec and are the same as on the source
video.
Lines Lines on which the VITC must be written on the monitoring output
connectors of the record codec. By default, these are lines 14-16 in
NTSC and 19-21 in PAL.
HD OUT
HANC LTC Field to specify if embedded timecode has to be inserted in the
output. The value specified has to be the same as for the HANC
VITC field. The possible values are:
No No new timecode inserted in the output.
In (default) Same timecode as in the input inserted in
the output.
LTC Timecode from the LTC table inserted in the
output.
USER User-defined timecode inserted in the
output.