VTech DS6472-6 Manual - Manual (Page 69)

64
Multiple handset use
PTT to a single handset
You have two ways to begin a PTT call:
If you have two handsets, press and hold PUSH TO TALK when
handset is not in use.
If you have three or more handsets, press
PUSH TO TALK when the
handset is not in use. Then use the dialing keys to enter a handset
number ( 1-9 for handsets 1-9, and 0 for handset 10, and
1 for handset 11 or and 2 for handset 12), or press or to
scroll to the desired handset then press SELECT . Press SELECT or
PUSH TO TALK to create the push-to-talk session.
Your handset displays Connecting to HANDSET X... for a few seconds.
When the connection is made, both your and the destination handsets
display Press and hold [PTT] to talk and beep once.
Press and hold PUSH TO TALK on your handset. A chirp indicates your
microphone is on. Speak towards the handset. Your voice is broadcast
to the destination handset. While you are speaking, the handset displays
PTT To HANDSET X (X represents the destination handset number).
Release
PUSH TO TALK after speaking. All handsets beep once again.
After the handsets beep, you can press and hold PUSH TO TALK to
continue speaking or the destination handsets can respond (see
Answer a PTT call on page 66).
Press
OFF/
CANCEL
or END to end the PTT call. The handset displays
Push to talk Ended for a few seconds.
- OR -
Place the handset in the telephone base or charger to end the PTT call.
1.
•
•
2.
3.
4.
After PUSH TO TALK is released, the PTT call remains open for a short
time. If no one presses PUSH TO TALK within 10 seconds, the PTT call
ends automatically.