Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Bullet Diesel Tuner '03-07 235, 250, 305, 325 HP Dodge 5.9L Cummins (24-valve) Trucks - Manual (Page 13)

96581 v.7.0
13
support below the steering column in
front of the firewall by removing the
two (2) bolts. This will allow access to
the inner grommet. See Figure 5.
7.
Route the Banks Bullet wire harness
(and EGT thermocouple lead wire
harness, if so equipped) through the
firewall to the passenger compartment,
leaving enough slack harness length
in the engine bay to allow for engine
movement without straining the sensor
connectors. Reattach bracket after
passing the Banks Bullet wiring harness
through the grommet.
8.
2003-2005 trucks Inside the truck
cab, gently remove the headlamp
control panel. See Figure 6.
2006-2007 trucks To remove the head
lamp control panel remove the two
Philip head screws located to the lower
right of the headlamp control panel.
See Figure 7. Note: the lower dash
panel previously removed in step 5
must not be installed to access screws.
now, gently unclip the upper left corner
of the headlamp control panel.
Note: the headlamp control panel
will not be removed from the dash.
Pull back on headlamp control panel
enough to access headlamp control
connector.
9.
With the headlight control panel
accessible, place one of the supplied
snap-on wire taps onto the ORANGE
wire with a BROWN tracer (ORG/BRN)
exiting the back of the instrument
dimmer switch. Be sure that the wire
tap snaps closed securely – firmly
squeezing it shut with a pair of pliers
will help ensure a proper electrical
connection. See Figure 8.
10.
Locate the Banks Bullet wiring
harness where it passes through the
firewall. Route the ORANGE wire with
the shielded male connection tab up
behind the dash and to the back of
the headlight control panel. Plug the
male connector tab into the wire tap
Figure 4