Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Bullet Diesel Tuner '03-07 235, 250, 305, 325 HP Dodge 5.9L Cummins (24-valve) Trucks User Manual
Page 20
20
96581 v.7.0
If your Banks Bullet Diesel Tuner has
been properly installed as outlined in
the previous section, it will power up
and briefly scroll ‘BANKS POWER’
across the screen, then display the
current power level setting after you
switch your ignition key on.
If the Bullet diesel tuner detects any
errors in installation wiring, sensor
readings, or internal hardware
functions, it will flash a message with
the detected errors immediately after
displaying the current power level
setting. Please refer to the following
section, ‘Troubleshooting’, for a full
explanation of the error codes, their
causes, and corrective actions.
Note: the Bullet diesel tuner
will automatically detect an eGt
thermocouple when one is properly
connected, and will configure the
available menus accordingly. If you do
not have a Banks eGt thermocouple
installed and properly connected to the
Bullet diesel tuner, none of the eGt-
related menus will be displayed.
If the Bullet diesel tuner does not
detect any errors in the system, it
will monitor and display the selected
default engine parameter in the
following format:
• Boost is displayed in PSI – the letter
‘B’ and one or two digits
• EGT is displayed in degrees
Fahrenheit – three or four digits with
no prefacing letter
• Fuel amount is displayed as a
percentage of stock fuel amount
entering the engine – the letter ‘F‘ and
three digits
• VER displays the tuner part number
and current firmware/calibration
version
Section 3
OPERATION OF THE BANKS BULLET DIESEL TUNER
Figure 14: Banks Bullet diesel tuner controls