Dexter Laundry T-30X2 EXPRESS - 60 Hz Gas (On-Premise) - Manual (Page 3)

3
TABLE OF CONTENTS
DRYER DIMENSIONS (Figure 1) 4
UNCRATING 5
INSTALLATION CLEARANCE (Figure 2) 6
DRYER EXHAUST SYSTEM (Figure 3) 9
DRYER SHUTDOWN 10
TOUCH PAD LAYOUT (Figure 4) 11
DRYER DEFAULT SETTINGS 12
DRYER FAULT CODES 12
TOUCH PAD DESCRIPTION 13
OPERATING INSTRUCTIONS 15
PROGRAMMING INSTRUCTIONS 17
SERVICING DRYER 23
PREVENTATIVE MAINTENANCE 23
WARNINGS ABOUT USE AND OPERATION
It is ABSOLUTELY ESSENTIAL that the dryer be grounded to a known earth (zero) ground in
accordance with local codes or, in the absence of local codes, with the latest editions of the
National Electric Code, ANSI//NFPA 70 or Standard CSA C22.1 Canadian Electrical Code Part
1. This is not only for personal safety, but is necessary for proper operation of the controller.
Failure to do so will void the warranty of the controller.
KEEP SHIELDS, GUARDS AND COVERS IN PLACE. These safety devices are provided
to protect everyone from injury.
THIS DRYER IS EQUIPPED WITH A MANUALLY RESETTABLE OVER-
TEMPERATURE THERMOSTAT located on the end of the burner housing above the gas
valve. Should the dryer cease to operate, refer to your “Service Procedure and Parts Data” book
for instructions.
CHECK THIS THERMOSTAT WHEN INSTALLING DRYER to assure it is not tripped.
Impacts, such as rough handling in shipment, may trip the thermostat. It may be reset by
inserting a wooden (nonconductive) pencil or dowel through the guide bushing in the cover.
NOTE: THIS APPLIANCE SHALL NOT BE USED TO DRY OFF SOLVENTS OR DRY-
CLEANING FLUIDS.