Armasight NYX-7 PRO 4.5x GEN 2+ ID Night Vision Bi-Ocular - Manual (Page 17)

17
1. Unscrew the battery cap (A) and insert the CR123A battery (B), observing the polarity markings on
the body of the device.
2. With the battery adapter (C) installed, screw the battery cap (A) back on securely.
Install the AA battery as follows:
1. Unscrew the battery cap (A).
2. Unscrew the battery adapter (C) from the cap, turn it around, and screw in the other end.
3. Insert the AA battery (D), observing the polarity markings as indicated on the body of the device.
4. Screw the battery cap (A) back into place.
3.1.2 MOUNTING AN IR ILLUMINATOR TO THE NYX7-4.5X PRO
To mount an IR illuminator to the Nyx7-4.5x PRO, use the optional transfer piece. Perform the following
steps:
1. Install the transfer piece (A) onto the Nyx7-4.5x PRO rail.
2. Tighten the fixing screw (B) on the transfer piece.
3. Loosen the IR illuminator fixing screw (C).
4. Mount the IR illuminator on the rail of transfer piece and tighten the fixing screw (C).
5. The IR850 runs on one CR123A battery. To install the battery, unscrew the battery compartment cap
and insert the battery in accordance with polarity markings. Screw the battery compartment cap (D)
back into place.
FIGURE 3-2. MOUNTING THE IR850 IR ILLUMINATOR TO THE NYX7-4.5X PRO
A
C
B
D
3.2 CONTROLS AND INDICATORS
The Nyx7-4.5x PRO controls and indicators are defined in Table 3-1.
The Nyx7-4.5x PRO controls are shown in Figure 3-3.
CAUTION:
DO NOT over-adjust the controls by forcing them past their stopping points.