Armasight DAMBIT05X05PAL1 BIT 5x Digital Night Vision Monocular - Manual (Page 20)

20
3.1.5 CONNECTING ADDITIONAL EqUIPMENT TO THE BIT
CAUTION:
Turn off the Bit before you begin connecting/disconnecting any external equipment and be-
fore removing the batteries.
Remove the batteries before you connect any external power source.
Remove the connector protective cap.
Connect a cable of Armasight DT digital video recorder or an external battery power supply to the Bit
connector.
FIGURE 3-5. ARMASIGHT DT DIGITAL RECORDER INSTALLATION
Use the plug A of a video cable to connect an external video recorder/monitor/TV to the Bit. Connect
the plug C of a video cable to the Bit connector.
Use the plug B of a video cable to connect an external power source (6 VDC/1A) to the Bit. Connect the
plug C of a video cable to the Bit connector.
A
B
FIGURE 3-6. VIDEO CABLE
C
NOTE:
The external power supply must have a standard 6mm OD double-pole socket with a positive
center contact.
CAUTION:
After removing the cable, replace the protective cap over the connector.