Xylem H-5223 - Manual (Page 68)

Description: Read the baud rate for the serial communications port.
Parameters: None.
Response: An ASCII text string is returned with the baud rate. The baud rate can be “ 300”,
“1200”, “2400”, “4800”, “9600”, or “19.2”. The response is terminated using a
carriage return, line feed.
Example: -> BAUDRATE?
5 Command sent to the XL™.
Baud Rate = 9600
rs Response sent to the host system.
Command: BAUDRATE=XXXX
Description: Set the baud rate for the serial communications port.
Parameters: Any of the following are valid baud rate parameters: “ 300”, “1200”, “2400”,
“4800”, “9600”, and “19.2”.
Response: None, use the BAUDRATE? command to see the new value.
Example: -> BAUDRATE=1200 5 Command sent to the XL™.
rs Response from the XL™.
Command: FLOWCONTROL?
Description: Read the flow control setting for the serial communications port.
Parameters: None.
Response: An ASCII text string is returned with the flow control. The flow control can be
“None”, “HW”, “SW”, or “Both”. The response is terminated using a carriage
return, line feed.
Example: -> FLOWCONTROL? 5 Command sent to the XL™.
Flow Control = None
rs Response sent to the host system.
Command: FLOWCONTROL=XXXX
Description: Set the flow control for the serial communications port.
H-5223
Remote Operation (Command Mode) C-9