Xylem CHATTER Notification System configuration guide - Manual (Page 15)

MANUAL
GB CHATTER NOTIFICATION CONFIGURATION 1303
15
Detailed configuration
General
Step Desription
1 Configure the Chatter Notification Engine to use the correct database.
Information about setting up the engine are found in
this chapter .
2 Define at least one rule in the configuration file cnsRulesEngineGlobalConfig.xml.
Information about how to set up rules are in
this chapter .
SCADA plug-in
Step Desription
1 Create at least one rule in the range 0 - 1999 the configuration file
cnsSCADAplugInGlobalConfig.xml.
Information about how to set up rules are in this chapter .
2 Create a corresponding entry in the cnsSCADAobjects table in the database
Information about how to create and name objects in the database are in
this chapter
3 Configure the SCADA plug-in to deliver its output data in a place to suit your needs
Information about how to configure this are in
this chapter
STORMFLOW plug-in
Step Desription
1 Create at the 2;M;1;0;M; rule in the configuration file
cnsRulesEngineGlobalConfig.xml.
Information about how to set up rules are in this chapter .
2 Create the necessary entries in the cnsSCADAobjects table in the database
Information about how to create and name objects in the database are in
this chapter
3 Configure the STORMFLOW plug-in settings to suit your needs.
Information about how to configure this are in
this chapter
22
16
16
39
29
16
39
37