Extron Electronics IPL T PCS4i - Manual (Page 14)

Front Panel
Features and
Operation
This section contains a description of the IPL T PCS4 and IPL T PCS4i front panel features
and instructions for setting up the PCS4 using the front panel. The following topics are
discussed:
• Front Panel Features
• Setting Up the System Using the Front Panel
• Resetting the Unit
Front Panel Features
IPL T PCS4
R
F
1
S
F
2
S
F
3
S
F
SET REFERENCE
FULL
100
LINK
ACT
STANDBY
S
4
1
3 4
6 6
2
5
7 6 7 7 7 6
Figure 7. IPL T PCS4 and IPL T PCS4i Front Panel
a Power LED (green) — When this LED is lit, the PCS4 or PCS4i power control interface
is receiving power and is running. When the unit is being reset, this LED blinks the
appropriate number of times to indicate the reset mode that has been entered.
b Reset button (recessed) — Use the tip of a Phillips screwdriver or a pointed stylus to
press this recessed button to reset the unit in one of four Reset modes (see “ Resetting
the Unit ” for details on reset modes and on using this button).
c Power control buttons 1-4 — Press these buttons to switch power on and off to the
output receptacle with the corresponding number on the rear panel. These buttons are
also used, along with the Set Reference buttons (
d ), to set the Full and Standby power
thresholds.
d Set Reference (Power threshold) buttons — Press these buttons to set the indicator
LEDs for each receptacle to indicate whether the attached devices are operating at Full
or Standby power level.
8 IPL T PCS4 • Front Panel Features and Operation