0 maintenance – Alpha Technologies XM3-HP Series - Technical Manual User Manual

Page 106

Advertising

106

017-882-B0-001 Rev. C2 (10/2013)

4.0

Maintenance

4.5

XM3-HP System Preventive Maintenance Log

4.0

Maintenance, continued

106

017-882-B0-001 Rev. C1 (09/2013)

4.0

Maintenance

4.5

XM3-HP System Preventive Maintenance Log

4.0

Maintenance, continued

Revised 08/26/10

XM3-HP Power System Preventive Maintenance Checklist

Lat: Long:

Hub:

Street:

Date: / /

Site Number:

City:

County:

Equipment Identification & As-Found Alarms:

Power Supply Make-Model:

PS1Serial #:

SM1Transponder:

Battery Make-Type:

Record as-found alarms:

PS Input Wattage:

PS Output Wattage:

Electric Meter #: Reading:
Battery Capacity:

Battery String Maintenance:

Battery #

Date Code

ID Number

Voltage- No Load (VDC)

Total String : .

Voltage-Under Load (VDC)

Total String: .

Conductance – (mhos)

F Corrected 77

A1:

A2:

A3:

A4:

B1:

B2:

B3:

B4:

Ignition Battery:

N/A

Battery String Replaced? Yes / No

Clean & no-ox battery terminals and lugs? Yes / No

Battery Torque (inch-pounds):

Power Supply Maintenance:

Power Supply #

Power Supply Events

AC Input Voltage (VAC) Output Voltage (VAC)

Output Current (Amps)

Number

Time

PS:

A .

B .

Clean and inspect each power supply? Yes / No

Run Power Supply Auto-Test? Pass / Fail

Clear Power Supply Event Log? Yes / No

Enclosure Interior and Exterior Maintenance Checklist:

Items to Check

Results

Items to Check

Results

Items to Check

Results

Clean dust/dirt from enclosure inside

Yes / No

Check LAP’s

OK / Replaced /

None Installed

Touchup paint enclosure exterior

Yes / OK

Change or clean enclosure air filters

Yes / No

Check Lamps & LED’s

OK / Replaced

Note Below

Note condition of retaining walls

Pass / Fail;

Note Below

Tighten all enclosure hardware

Yes / No

Cut weeds back 36” from enclosure

Yes / No / NA

Any pad undermining?

None / Yes;

Note Below

Inspect wire harnesses and connectors

Pass / Fail

Cleanup garbage within immediate

vicinity

Yes / No / NA

Any enclosure damage or vandalism

None / Yes;

Note Below

Inspect battery temperature probes

Pass / Fail

Is powernode site ID legible?

Yes / No / NA

Power Supply 120 v or 240 v

120 / 240

Inspect for rodent and insect damage

Yes; Note

Below / OK

Clean enclosure exterior & remove

graffiti

Yes / No

Generator Cord Present?

Yes / No /

Installed

Comments & Replacement Parts Used: _____________________________________________________________________________

_______________________________________________________________________________________________________________

PM Service Technician: _____________________________

Advertising