Alpha Technologies XM3-HP Series - Technical Manual - Manual (Page 65)

65 017-882-B0-001 Rev. C2 (10/2013)
3.0
Operation
3.3.3 Communication Information and Configuration
Pressing the COMM softkey while in the OPERATION NORMAL screen opens the following
display (the first letter of the top line will blink indicating it is the active line).
C OMM - FAULT
COMM - GENERAL
COMM - EXTENDED
ENTR
ESC
COMM-GENERAL
In this case, pressing Enter <ENTR> will open the
COMM-GENERAL Menu enabling the operator to
view values for the following parameters. Pressing
the up or down arrow softkeys will show two lines of
information for each submenu item.
COMM-FAULT
The top line of the display is affected by pressing
a softkey. Pressing Enter <ENTR> will open the
COMM-FAULT Menu. The COMM-FAULT Menu
will appear if there is no RF connection or the RF
connection is interrupted.
COMM-GENERAL
CM MAC ADDRESS
00:90:EA:A0:04:99
ESC
COMM-FAULT
RF POWER LEVEL FAULT
SEE GENERAL MENU
ESC
Press "Down" arrow softkey to
view next item(s) in menu.
3.3 Smart Display Menus, continued
3.0 Operation, continued
COMM GENERAL
CM MAC ADDRESS
00:90:EA.A0:04:99
CM IP ADDRESS
192.168.1.121
CM IPV6 ADR PREFIX*
2001:123:456:789
CM IPV6 ADR POSTFIX*
111:222:333:3434
CPE MAC ADDRESS**
00:90:EA:A0:04:9A
CPE IP ADDRESS**
192.168.1.122
CM RECEIVE POWER
-2.1dBmV
CM TRANSMIT POWER
48.5dBmV
DOWNSTREAM SNR
40.5dB
* Menu item available if DSM3 is provisioned
in IPv6 mode
** Menu item available if DSM3 is provisioned
in Dual-IP mode