Castle TSM-35 Operator Manual - Manual (Page 11)

CASTLE, INC TSM-35 OWNERS MANUAL V1.2 Page 11 of 33
5 Machine Adjustments
Your TSM-35 comes factory-adjusted to handle typical pocket-hole needs. Some additional
adjustment may be necessary after you have satisfied the air and electrical requirements
explained above. Your pockets are adjusted at the factory for a 1 1/4” length screw.
Note: For your safety, before making any adjustments please make sure that the red Stop
Button is in the OFF position and both power and air are disconnected.
5.1 Web Adjustment
In the event that you wish to experiment with different length screws for different applications,
your TSM-35 has what is called a Web Adjustment. This adjusts the distance from the front of
the pocket to the edge of the material, as shown below.
Fig 1
1. Turn off Air to the machine and lift the Case Top to its fully opened position.
2. Locate the
7
/
8
” x 2” plate mounted on the back of the white pallet, to the right of center,
behind the air drill motor.