Castle TSM-35 Operator Manual - Manual (Page 12)

CASTLE, INC TSM-35 OWNERS MANUAL V1.2 Page 12 of 33
3. Use a
7
/
16
” wrench to loosen both of the ¼” hex head cap screws on the
7
/
8
” x 2” plate.
Note: Do not loosen more than ¾ of a turn.
4. Once both bolts are loose the plate can move forward and backward. By moving the
plate toward the rear of your machine, your pocket will adjust for a shorter distance from
the edge of your material. Moving the plate toward the front of the machine will adjust for
a longer distance from the edge of your material.
5. This is a trial and error method and should be moved only a small amount at a time.
6. After making each adjustment, snug down the ¼” hex head cap screws with your
7
/
16
” wrench each time.
Be sure to close the Case Top and turn on air before trying to start your machine. The machine
will not start with the Case Top open or with the air off.
5.2 Pocket Depth Adjustment
In the event that you wish to adjust the depth of your pocket for shorter or thicker material, your
machine has a Pocket Depth Adjustment.
Fig 2
1. Turn off Air and Electrical power to your machine and raise the Case Top to its fully
open position.
2. With wrenches provided, loosen the collet and move the router bit up or down slightly in
the collet. Re-tighten the collet before testing.