CEMB USA C61 (D) - Manual (Page 8)

Pos. A
Pos. B
I 0184 - 8 GB
5 -INDICATION AND USE OF THE WHEEL BALANCER
5.1 - DOUBLE OPERATOR PROGRAM
This program allows memorizing the dimensions of two types of wheels. Thus two operators can work
simultaneously on two different cars using the same balancing machine. The system memorizes two
programs with various preset dimensions.
1 - Press to select operator (1 or 2). Selection is confi rmed by panel-mounted Led.
2 - Enter the dimensions (see
PRESETTING OF WHEEL DIMENSIONS).
3 - perform balancing as usual
With program 1 or 2 is called for subsequent balancing operations without having to newly enter
the dimensions.
5.2 PRESETTING OF WHEEL DIMENSIONS
5.2.1 - (Automatic presetting C61Z )
- Standard wheels (calibration necessary also for modes ALU 1, 2, 3, 4, Static)
Fig. 5 DISTANCE + DIAMETER
Move the gauge tip into contact against the rim (fi g. 5) keeping it in position
for at least 2 seconds.
Note: Measurement is identical in position A or B. Always use the round part
of the striking block.
Indication of gauge in movement Fig. 5A
Indication of dimension acquired Fig. 5B
Note: If the acoustic signal is enabled (see OPERATION FUNCTIONS MENU ), the
acquisition of the dimensions is accompanied by a “beep”
Return the gauge to position 0.
The system automatically switches to WIDTH position.
Fig. 6
- Set the rated width, which is generally
indicated on the rim, or measure width
“b” using the compass gauge supplied.