Biamp A4 - Manual (Page 179)

System Design
Once reset, Compile will automatically re-assign channel numbers.
Message: Nothing to compile !
Explanation: All objects placed in layout have been ignored.
Messages: Insufficient audio inputs and outputs to implement this layout.
Insufficient audio inputs to implement this layout.
Insufficient audio outputs to implement this layout.
Explanation: The design requires more input/output channels than are available
from the Audia device(s) specified in the Equipment Table . This
can only occur if the flag 'Auto Device Add' is not set under
Tools>Options>Compile .
Message: Insufficient computing power to implement this layout.
Explanation: The design requires more DSP resources than are available
from the Audia device(s) specified in the Equipment Table . This
can only occur if the flag 'Auto Device Add' is not set under
Tools>Options>Compile .
Message: Feedback loop detected.
Explanation: The potential exists for an audio path to be indirectly looped back
upon itself. This condition could be dangerous, and is not allowed.
Messages: Specified Audia unit #__ is not in the Equipment Table.
Specified Audia unit #__ is not selected for use.
Explanation: Some DSP blocks have been assigned as fixed allocations in a
specific Audia unit which is not available or selected for use.
Messages: Too many audio inputs required for fixed allocations in unit #__.
Too many audio outputs required for fixed allocations in unit #__.
Too many I/O channels required for fixed allocations in unit #__ (FLEX units).
159