Gardner Bender KKT316 KEYWAY CUTTER - Manual (Page 2)

WARRANTY: GB ELECTRICAL, INC. warrants its
products against defects in workmanship and
materials for 1 year from date of delivery to user.
Chain is not warranted. Warranty does not cover
ordinary wear and tear, abuse, misuse, overloading,
altered products or use of improper fluid. WARRANTY RETURN PROCEDURE: When
question of warranty claim arises, send the unit to the
nearest GB Authorized Service Center for inspection,
transportation prepaid. Furnish evidence of purchase
date. If the claim comes under the terms of our
warranty the Authorized Service Center will REPAIR
OR REPLACE PARTS AFFECTED and return the unit
prepaid. PARTS AND SERVICE: For quality workmanship and
genuine GB ELECTRICAL parts, select an Authorized
GB Service Center for your repair needs. Only
repairs performed by an Authorized Service Center
displaying the official GB Authorized sign are backed
with full factory warranty. Contact GB Electrical
(414) 352-4160 for the name of the nearest GB
Authorized Service Center.
REPAIR AND SERVICE INSTRUCTIONS: For repair service and parts contact your nearest GB ELECTRICAL
Service Center. The Service Center will provide complete and prompt service on all GB ELECTRICAL products.
GB Electrical, Inc.
An Applied Power Company 6101 N. Baker Road, Milwaukee, WI 53209
Phone: (414) 352-4160
FAX (414) 352-2377
RPS-0059 Rev. A 03/07
Keyway Cutter with 1” Socket Wrench
1. Loosen the cutter jam nut, 2 or 3 turns. Insert the
cutting tool into the 1
7 ⁄
32
” panel opening until the pilot
shoulder extends into the hole and the die rests against
the panel. (Figure 2)
2. Hand tighten the jam nut to draw the cutter blade
against the panel. Position the alignment notch at the
location where the keyway is required.
3. Install a 1” socket and handle over the jam nut. Turn
the handle until the cutter blade makes a clean cut
through the panel. (Figure 3)
Maintenance
1. Keep all threads clean and lightly oiled to prevent rust
and enable smooth operation.
2. If keyway cutting blade becomes dull or damaged,
replace it immediately.
3. Keyway cutter replacement parts are available from
your closest GB Service Center.
Operation
Prior to using the keyway cutter, a 1 7 ⁄
32
” hole must be made
for the switch or component mounting (KOM1732).
Keyway Cutter Using Hydraulic Knockout Cylinder
1. Remove the punch and die from the punch cylinder.
Remove the cylinder pull stud.
2. Remove the large jam nut from the keyway cutter.
3. Thread the tool into the cylinder pull rod until the cutter
die rests against the cylinder.
4. Insert the cutter tool into the 1 7 ⁄
32
” panel opening until
the pilot shoulder fits into the hole and the die is
against the panel (Figure 1).
5. Turn the cutting tool until the alignment notch is located
where the keyway is desired.
6. Activate the hydraulic pump until the cylinder pulls the
cutter blade through the panel material.
Figure 2
Figure 1
Knockout
Cylinder
Panel Alignment
Notch
Keyway
Cutter
Figure 3
Socket
Keyway
Cutter
Jam Nut
Alignment
Notch
Cutter Blade
Die