Hydra-Flex Aqua-Lab MD Installation Manual - Manual (Page 10)

Installation Manual
© Hydra-Flex Inc 2011 - 8 -
Feed Water Connection
**PRIOR TO CONNECTION, ENSURE THAT THE FEED LINES ARE FREE OF DEBRIS BY FLUSHING OUT THE
LINES FOR 15 MINUTES
• Connect pre-run main water supply line to pump inlet with hose
supplied.
o Single operating pump: 1” MNPT
o Dual operating pump: 1-1/2” MNPT
Pneumatic Connections
**IF AIR IS NOT REQUIRED FOR YOUR AQUA-LAB, PLEASE SKIP THIS
SECTION
• Connect pre-run 3/8" OD poly feed line to push connect fitting on the
side of the primary regulator
• Connect 3/8” OD poly lines from arch to each port that will be
foaming
**If there are unused air ports, back out the individual line regulator
until air no longer flows