Laurel Electronics LAUREATE SERIES 2 COUNTER-TIMER-SERIAL INPUT METER - Manual (Page 37)

37
Press
Menu Press Digit
Select Key Press Value Select
Key
Coordinates of 2 points scaling method if selected under SEtuP
. Lo_In1 .
Low signal
input 1.
000000 000000 000000
000000 000000 000000
Select digit to flash.
Select -9 thru 9 for flashing first digit and 0 thru 9
for other flashing digits. Move decimal point location
when flashing.
Lo_ rd1
Reading at
Lo In1.
000000 000000 000000
000000 000000 000000
Select digit to flash.
Select -9 thru 9 for flashing first digit and 0 thru 9
for other flashing digits. Decimal point is fixed by
dEC.Pt1 .
. Hi_In2 .
High signal
input 2.
000000 000000 000000
000000 000000 000000
Select digit to flash.
Select -9 thru 9 for flashing first digit and 0 thru 9
for other flashing digits. Move decimal point location
when flashing.
. Hi_rd2 .
Reading at
Hi In2.
000000 000000 000000
000000 000000 000000
Select digit to flash.
Select -9 thru 9 for flashing first digit and 0 thru 9
for other flashing digits. Decimal point is fixed by
dEC.Pt1 .
Special curve offset for square root or custom curve linearization if selected under ConFiG
. rd0_In . 000000 000000 000000
000000 000000 000000
Select digit to flash.
Select -9 thru 9 for flashing first digit and 0 thru 9
for other flashing digits. Decimal point is fixed by
dEC.Pt1 . Enter 04.000 for square root extraction
with a 4-20 mA signal.
Scale multiplier
rESoLn .
Resolution
Flashing 6-digit number
in decade steps from
0.00001 to 100000
Press to select. This multiplier R appears with the
Batch mode and can be applied to Grand Total to
set its decimal point.
Quartz crystal time base calibration
_CALib Time base calibration. Do not change. See Calibration section of manual.
Option dependent menu items
SourcE AL SEt . AL S34 dEUn1H dEUn2H dEUn1b dEUn2b dEUn3H DEUn4H DEUn3b
DEUn4b Menu items related to alarm setup These will only appear if a relay board is
detected. If so, please see Section 14.
An_SEt An_Lo An_Hi or An_SEt An_Lo1 An_Hi1 An_Lo2 An_Hi2 Menu items
related to analog output. These will only appear if a single or dual analog output board is
detected. If so, please see Section 15.
_SEr_1 _SEr_2 _SEr_3 _SEr_4 Menu items related to serial communications. These will
only appear if an RS232 or RS485 I/O board is detected. If so, please see Section 16.
Menu lockout items
_Loc_1 _Loc_2 _Loc_3 _Loc_4 Menu items used to enable or lock out (hide) other menu
items. Loc menu items may be locked out by a hardware jumper. Please see Section 9.