Dixon Valve 25 TON RAM Complete Manual User Manual
Page 58
Advertising
25 Ton Ram Instruction Manual
Converting from Swaging to Expansion
customer service
800
•
355
•
1991
1
Section 5
Loosen the keeper plate bolts, and remove all die
holders.
Install the retaining bolt with washer into hole of
the main Ram pusher plate (
25T5).
Before you begin make sure the Ram is fully
retracted. Remove the
25PUSH400
(also referred to as the pusher hat) from the main
pusher plate, if installed on the Ram.
Laying the
25IXATTACH on it’s side, move the
guide plate to the center. Slide the retaining collar
up until it contacts the guide plate. Tighten the set
screw in the retaining collar.
Stand the
25IXATTACH up so that the end with the
slot is on top.
3
2
4
1
Advertising