Manifold pressure (m-1) wiring diagram – Electronics International M-1 Manifold Pressure User Manual

Page 10

Advertising
background image

Manifold Pressure (M-1)

Wiring Diagram

8

Do not use screws longer
than 1/2" (4 ea.).

Analog LED Lighting Control Line, connects to Panel Light Rheostat.
12/24 volts dims the analog LEDs.



Optional) External Warning Control Line. Can be connected to a relay

to control an external light, buzzer, etc. Grounds when Red Warning
Light is on. Current must be limited to 2/10 amp maximum.

24V Backlight Control Line, connects to Red Power Lead for 24V
system. Connects to ground for 12 Volt System.

12V Backlight Control Line, connects to Red Power Lead for 12V system.
12 volts turns on the digital display backlight.

Ground Lead, connects to Ground.

Power Lead, connects to 12 or 24 Volt Bus via one amp fuse.

White/Yel

Black

R e d

White/
Brwn

White/Red

White/
O r n g

Circular Connector

Pressure Port.

Aircraft Manifold Pres-
sure Line.

Wire Harness

WD 0313911

Rev. A: 6/16/92

Advertising
This manual is related to the following products: