General Tools and Instruments DCS100 - Manual (Page 11)

OPERATING INSTRUCTIONS
NORMAL OPERATION
In most cases, you will perform some or all of the following steps each
time you use the Seeker 100 and RCV100 for an inspection session:
• Start ScopeView
• Power on your Seeker 100 and sync it to the RCV100
• Plug the RCV100 into your computer
• Configure the connection (set video and photo resolutions,
formats and storage locations)
• Capture videos and pictures
• Browse, edit and play back videos and pictures
• Print pictures
To perform these tasks, you will use six features of ScopeView:
• The main menu
• The toolbar below the main menu
• The Preview Pane at the left of the main window
• The Photos and Videos tabs of the Preview Pane
• The Photo Control bar
at the bottom of the main window
• The status bar at the bottom of the ScopeView window
To view live video, start ScopeView, power on your Seeker 100 and
click the tab. You can change the size (horizontal x vertical
pixels) of the live feed that appears in ScopeView’s main window
by right-clicking on the video. The options include ten different
combinations of size and aspect ratio, plus maximum size.
11