General Tools and Instruments DCS100 - Manual (Page 6)

6
2. THE RCV100 WIRELESS USB VIDEO RECEIVER
COMPONENTS
The RCV100 ships with an installation
CD, a 3 ft. long USB extension cable
and a video input cable.
1. Wireless receiver
2. Installation CD
3. USB extension cable
4. Video cable
3. ANATOMY OF THE
RCV100 RECEIVER
A. USB plug
B. “Connected” light
C. Black CH button for channel
selection
D. Power/Channel indicator
light; number of flashes
corresponds to channel
numbers from 1 to 4
E. Video in jack
SETUP INSTRUCTIONS
Before using the Seeker 100, make sure it is assembled and fully
charged. If the 1m probe is not already attached to the grip, connect
the two components by inserting the keyed end of the probe into the
connector at the front of the grip, making sure that the alignment key
at the end of the probe lines up with the flat on the connector’s
housing. Then tighten the connection by turning the collar clockwise.
Finally, remove the rubber cap that protects the camera and the LEDs
on the other end of the probe.
1.
2.
3.
4.
A.
B.
C.
D.
E.