General Tools and Instruments DCS400-495 - Manual (Page 8)

13
Default Setup
1. In the setting mode, press the or
button to select “SYSTEM SETTING” press
the “OK” button to enter.
2. Press the or button to select
“Default Setup” press the “OK” button to
enter into the following interface:
3. Press the or button to select “YES”, pressing the “OK”
button will restore defaults; NO will be to exit.
View Version Information
1. In the setting mode, press the or button to select
“SYSTEM SETTING”, then press the “OK” button to enter.
2. Press the or button to select “Version” then press the
“OK” button to enter and view the version of the product.
Frame Rate Setting
1. In the setting mode, press or button
to select “RECORDER SETTING” then press
the “OK” button to enter.
2. Press the or button to select
“Frame Rate” then press the “OK” button
to enter into interface:
3. Press the or button to select a suitable frame rate.
4. Press the “OK” button to confirm and exit.
Time Stamp Setting
1. In the setting mode, press the or
button to select “RECORDER SETTING”
press the “OK” button to enter.
2. Pressthe or button to select
“Time Stamp” then press the “OK” button
to enter into the following interface:
3. Press the or button to select “Off” or
“On” then press the “OK” button to confirm and exit.
8
OPERATION
Basic Operation
1. Roll the ON/OFF switch to turn ON the camera; the power
indicator will light up. The switch then acts as a dimmer for the
twin LED’s that surround the camera on the probe’s tip.
2. Press and hold on the Power ON/OFF button on top of the
monitor for 2 seconds; the power indicator will light-up green,
then press the button to select “CH4” (channel 4) and the
picture will display on the LCD of the monitor. Press the
button to select “record video” or “take pictures” status.
3. Roll the ON/OFF light switch for a better image effect.
4. When in use, maneuver the probe into position.
ON
OFF