Gentec-EO UP and XLP12 - Manual (Page 9)

Version 5.0
Ultra Series UP Instruction Manual Gentec Electro-Optics Inc. All rights reserved
5
1.2.6 Molex-BNC (BT version)
The Molex-BNC connection, available in the UP with amplification, allows you to power the internal
circuit board (PCB) with the Molex connector and to read the signal with the BNC connector (load
impedance : 10 M
Ω). The PCB needs +12 to +16V from a regulated power supply but does not
need negative voltage.
FIG. 1-7 MOLEX CONNECTOR PIN-OUT IN BT VERSION