APC NetworkAIR Rack Air Removal Unit ACF102BLK - Manual (Page 11)

Installation
NetworkAIR Rack Air Removal Unit Installation 7
Install the fan assembly
1. Align the lower pin with the hole in the hinge
pin bracket on the fan frame and insert the pin
into the hole.
2. Align the upper hinge hole with the hole in
the upper hinge pin bracket and insert the
hinge screw into the holes.
3. Tighten the hinge screw with the included
5/32" hex wrench.
Warning
To prevent the enclosure from tipping, all four pins must be in engaged in the
enclosure frame before installing the fan assembly.
Warning
To avoid personal injury or damage to the Rack Air Removal Unit or the
enclosure, two people should support the fan assembly while another places the
fan assembly onto the enclosure.