King Kooker Cast Cookers with Gas Shut Off Technology - Manual (Page 11)

11
Tools Required:
Torque Wrench or Adjustable Wrench, Leak Testing Solution and
Phillips Head Screwdriver
ASSEMBLY
1. Read assembly instructions, and understand sequence of assembly, before commencing to assemble
your cooker.
2. The casting for your cooker must be installed into the unit as instructed below before use. The
assembly of the casting is required to be done with the unit in an upside down position. After assembly
the unit should be turned to an upright position for use.
.
Installation of Casting:
a. Remove top nut from casting bolt.
Leave bottom nut attached and tightened.
b. Flip cooker upside down. Insert casting with the
bolt pointed up through the shroud opening.
c. Place the casting bolt through the hole on the
flat bar.
d. Reinstall nut to casting bolt. Tighten.
e. Turn the unit upright. Check to see if the
casting is pointing straight up and is sturdy.
* Above Figure Does Not Show Hose/Valve Assembly
Which Will Be Pre-Assembled to the Casting
3. Refer to Figure 2 below for picture of a properly installed burner/gas train assembly.
FIGURE 2