Robinair 34134Z Refrigerant Recovery, Recycle, Recharge Unit - Manual (Page 10)

© 2003 SPX Corporation
8
NOTE: At this time, the unit is also automatically evacuating all air from the unit.
7. With the vacuum pump running, slowly add oil until the level rises to the
center of the oil sight glass.
8. When the vacuum pump countdown reaches zero, the vacuum pump will
stop and the unit display will change to the recover function.
9. Replace the plastic plug in the oil fill port.
After adding oil to the vacuum pump, add refrigerant to the internal storage
vessel. Refer to the instructions on the next page.
Note: The unit’s
weight default is in
pounds. To change
to kilograms:
1. Press the
Up and
Down arrow keys
at the same time.
will be displayed.
2. Press the Up or
Down arrow key
to toggle to KG.
3. Press Mode key
until display reads
EXIT.
UNITS LBS
Initial Setup
Adding Vacuum Pump Oil contd.