IAI America ISPDACR-ESD - Manual (Page 42)

34
5. Installation
5.4 Mounting Surface
x The mounting frame should have sufficient rigidity to avoid generation of vibration.
x The surface where the actuator will be mounted should be machined or be equally level, and the
flatness between the actuator and the frame should be within 0.05 mm.
x Provide enough space around the actuator so that maintenance work can be carried out.
x The side and bottom of the actuator base provide reference planes for slider travel.
x When traveling precision is required, use these surfaces as the reference for mounting.
As shown in the figure above, each side face of the base provides a reference surface for traveling
alignment of the slider. If accuracy is required, install the actuator with reference to this surface.
When installing the actuator on a frame using a reference surface of the base, follow the figure below.
With the ISPDCR-W, ISDACR-W and ISPDACR-W actuators, the front cover and rear cover located at both
ends of the actuator make contact. When machining the necessary locations, therefore, provide sufficient
allowances corresponding to the thickness of each cover to prevent contact.
Type Dimension A (mm)
S 2~5
M xMX 2~5
L xLX 2~5
W 3~5
Reference
surface
Reference
surface
Reference
surface
Reference
surface
Reference
surface
Reference
surface
R0.3 or
less