IAI America ISPDACR-ESD - Manual (Page 43)

35
5. Installation
5.5 Using T-slots
M4 T-slots are provided on the side face of the base for installing the connector box or other item that must
be combined. (See the figure below.)
If a wiring kit is combined, use these T-slots to install the kit.
You can also use these T-slots freely for installing sensors, securing wires or for other purposes as
necessary.
Caution: Square nuts are recommended for use with T-slots, but general hexagonal nuts can also be
used. When installing bolts in T-slots, pay attention to the length of each bolt to prevent the
bolt tip from contacting the bottom of the T-slot.
Distance
from bolt tip
Square nut
(or hexagonal nut)
Installed
part
Bolt