King Electric SRK10 splice/tee kit - Manual

SRK10 Splice and Tee Kit with End Seal
Installation, Operation and Maintenance Instructions
IMPORTANT: Save These Instructions!
WARNING : ELECTRIC SHOCK HAZARD
Disconnect all power before installing or servicing
the heating cable and accessories. SR heating
cable must be grounded properly in accordance
with the National Electrical Code (NEC). Failure to
comply can result in personal injury or property
damage. Only a qualified licensed electrical
contractor shall install and service of SR heating
cable and accessories, otherwise the warranty is
voided.
Note:·All electrical wiring, including Ground Fault
Circuit Interrupters (GFCI), must be done
according to the NEC and local codes by a
qualified installer. Article 426 of ANSI/NFPA 70 of
National Electrical Code (NEC section 62 of
CAN/CSA-C22.1, Canadian Electrical Code, Part I
(CEC) governs the installation of this heat systems
DESCRIPTION
The SRK10 Splice and Tee kits are to
be used with King SR heating cables.
Carefully follow these instructions. Do
not use other materials or alternate
splicing methods which may damage
the heating cable and create an
electrical hazard, risk of fire, or poor
performance.
SRK10 SPLICE AND TEE KIT
The SRK10 kit is to be used with King
SR heating cables to make a splice, tee
connection and one end seal.
CAUTION: Charring or burning the
heat shrink tubing can produce fumes
that may cause eye, skin, nose and
throat
irritation. Use adequate
ventilation during installation and avoid
overheating the heat shrink tubing.
TOOLS REQUIRED: utility knife, cross
cutters, needle nose pliers, crimping
tool, heat gun.
Rev 9.15.12 www.king-electric.com 1
Item Qty Description
A 1 Black heat shrink tube for ground
B 2 Insulated buss wire crimp connectors
C 3
Black heat shrink tube (1/2” dia. x 1” length)
D 1 Un-insulated ground crimp connector
E 6
Black heat shrink tube (1/8” dia. x 1” length)
F 2
Heat shrink cap (1/2” dia. x 2” length)
G 5 Mastic strips (1” width x 1-1/2” length)
H 1
Black cloth tape (1” width x 6” length)
I 1 Cable tie with mounting hole
J 3 Cable ties
K 1 Black heat shrink tube (1” dia. x 8” length)
X 1
Black heat shrink tube (3/4” dia. x 5” length)
Y 1 Woven braid sleeve ( ½” dia. x 4” length)
Z 1
Black heat shrink cap ( ½” dia. x 1-1/4” length)