Teledyne LeCroy WaveRunner МXi-A Getting Started Manual - Manual (Page 99)

Getting Started Manual
922138-00 Rev A 91
B
Setting the Date and Time
The instrument gives you the choice of manually setting the time and date or
getting it from the Internet. If you elect to get the time and date from the
Internet, you need to have the oscilloscope connected to the Internet through
the LAN connector on the rear panel. You can also set time zones and daylight
savings time.
Manually Setting the Date and Time
Touch Utilities  Utilities Setup... from the menu bar.
Touch the Date/Time tab.
Touch inside each of the Hour, Minute, Second, Day, Month, and Year fields
and enter a value, using the pop-up numeric keypad.
Touch the Validate Changes button.
Setting the Date and Time from the Internet
The Simple Network Time Protocol (SNTP) is used.
Ensure that the oscilloscope is connected to the Internet through the LAN
connector at the rear of the instrument.
Touch Utilities  Utilities Setup... from the menu bar .
Touch the Date/Time tab.
Touch the Set from Internet button.
Setting the Date and Time from Windows
Touch Utilities  Utilities Setup... from the menu bar .
Touch the Date/Time tab.
Touch the Windows Date/Time button
Use the Time & Date Properties window to configure the time, including time
zone.