IEI Integration KINO-945GSE2 - Manual (Page 64)

KINO-945GSE2 Motherboard
Page 52
4.5 Jumper Settings
NOTE:
A jumper is a metal bridge used to close
an electrical circuit. It consists of two or
three metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic clip and to OPEN a
jumper means removing the plastic clip from a jumper.
Before the KINO-945GSE2 is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the KINO-945GSE2 are listed
in
6
Table 4-1.
Description Type Label
ATX control 3-pin header ATXCTL1
Clear CMOS 3-pin header J_CMOS1
COM4 mode setting 6-pin header JP2
COM6 mode setting 6-pin header JP4
LVDS1 voltage selection 3-pin header J_VLVDS1
LVDS2 voltage selection 3-pin header J_VLVDS2
LVDS1 panel resolution 8-pin header J_LCD_TYPE1
LVDS2 panel resolution 4-pin header J_LCD_TYPE2
Table 4-1: Jumpers
4.5.1 AT/ATX Selection
Jumper Label: ATXCTL1
Jumper Type: 3-pin header