IEI Integration KINO-PV-D4252_D5252 - Manual (Page 62)

KINO-PV-D5252/D4252 Mini ITX SBC
Page 48
 Turn all power to the KINO-PV-D5252/D4252 off:
o When working with the KINO-PV-D5252/D4252, make sure that it is
disconnected from all power supplies and that no electricity is being fed
into the system.
Before and during the installation of the KINO-PV-D5252/D4252 DO NOT:
 Remove any of the stickers on the PCB board. These stickers are required for
warranty validation.
 Use the product before verifying all the cables and power connectors are
properly connected.
 Allow screws to come in contact with the PCB circuit, connector pins, or its
components.
4.3 Unpacking
When the KINO-PV-D5252/D4252 is unpacked, please check all the unpacking list items
listed in Chapter 3 are indeed present. If any of the unpacking list items are not available
please contact the KINO-PV-D5252/D4252 vendor reseller/vendor where the
KINO-PV-D5252/D4252 was purchased or contact an IEI sales representative.
4.4 SO-DIMM Installation
SO-DIMM is a critical component of the KINO-PV-D5252/D4252. If it is not installed the
KINO-PV-D5252/D4252 cannot run.